Advice
Catalytic liners, and the ten second check before you spray
East Cambs Oven Cleaning, Burwell, Cambridgeshire. Published 15 September 2026.
The short answer
What are catalytic liners in an oven? Grainy panels on the side and back walls that take grease into the surface as you cook, and shed it when the oven runs hot: AEG says the absorbed grease loosens at 250°C, above normal roasting. Put a hand on the wall: gritty means a liner, glassy means enamel. Caustic cleaner wrecks a liner for good.
The ten second check, with the flat of your hand
You do not need the manual, and this is quicker than finding one. Let the cooker go cold, open the door, lay a flat hand against the side wall about halfway up and move it an inch or two. You are feeling for one thing. Does the surface drag, or does it slide?
Drag means a catalytic liner. The panel is deliberately grainy, somewhere between a fine sandpaper and an unglazed tile, and your palm catches on it. Slide means vitreous enamel, which is glass fired onto steel and feels like the inside of a bath. Feel both once and you will never mistake one for the other again.
Both side walls
Start here. Where an oven has liners, the sides are where they are, and they normally run the height of the cavity. Feel high as well as low, because the top of a wall is where spitting fat lands.
The back panel
Often the third one. Feel to the side of the fan cover rather than on it, because the cover is a separate pressed plate and not a liner.
The floor of the cavity
Almost always plain enamel, and that is why the base takes a soak and a blade held flat while the walls beside it must not. One oven, two different jobs.
The door
Glass and a framed edge, so it cleans like glass. Not a liner, and the brown film on it is a different problem with a different answer.
If it is still borderline
The rating plate inside the door frame carries the model number, and the manual settles it. Until it does, treat the walls as liners. Treating enamel gently costs nothing. Treating a liner like enamel costs the panels.
What the panels are doing while you cook
A liner is not a coating that keeps dirt off. It is a surface that takes dirt in. The grain gives fat somewhere to go instead of sitting on top of the wall in a bead, and that much happens quietly on a Sunday while the chicken is in. Shifting it is the other half, and it wants more heat than a roast: AEG says the absorbed grease “becomes loosened when the oven reaches 250°C”, against the 180 to 220 most things cook at. Their own routine is to take the shelves and supports out, run the empty oven on its cleaning setting for an hour, and wipe the floor of the cavity when it has cooled. That is why the makers tell you to run it empty and hot now and then, which otherwise sounds like fussing.
That is the real difference between a liner and a pyrolytic cycle. One works at the temperatures you already cook at and deals with a little at a time. The other locks the door and burns the lot off in one go. They are not two versions of the same idea and they do not want the same treatment.
It also explains the limit. A liner only handles what lands on it, at the pace your cooking sets. The panels are doing their job. They were never asked to do the rest of the oven.
What ruins a liner, and why nothing brings it back
The roughness is the working part. Take that away and there is nothing left to work with, which is why this is permanent rather than a setback. Four things do it: caustic oven cleaner, wire wool, a scouring pad, and any cream or powder that cleans by grit. A blade belongs on glass and on a hob, never on a panel like this.
Caustic goes after the surface itself and strips it. Abrasives wear the grain flat and press old grease into whatever is left. Either way the panel stops taking anything in and behaves from then on like a rough plate that simply holds dirt. No product puts it back. The only fix is new panels, on a cooker that was working perfectly well ten seconds earlier.
That is why we check before anything goes near the sides. It takes no longer than your hand on the wall just took, it happens on every oven whatever the make, and it costs you nothing.
Every oven gets the hand check before a cloth or a cleaner touches it, and the number you are quoted is fixed before we arrive.
Get a priceLooking after liners, which is less work than you think
Hot water, a cloth, and a little washing up liquid if you want it. That is the list. Wipe the panels while the cooker is warm rather than hot, take the loose soil off, and leave them be. You are not trying to get them back to the colour they were in the showroom, because that is not what a working liner looks like.
The other half is the makers' own advice, and it is worth reading rather than guessing at: run the oven empty and hot so the liners can deal with what they have taken in. The setting and how long to leave it differ by model, and the manual for your oven is the thing that says. We are not going to put a temperature and a time on this page for an appliance we have not seen.
What not to do is shorter still. No caustic, nothing abrasive, no soaking the panels. And if a spill has landed on the floor of the cavity rather than on the walls, treat the floor as enamel and the walls as liners, in the same oven, on the same afternoon.
Why the check comes before anything else here
Because a tub, a bag kit and a spray bottle cannot tell the difference, and neither can anybody who has not put a hand in. It is the first thing that happens on a job, before a cloth comes out, and where the walls are liners they are cleaned by hand with hot water while the rest of the oven gets the full treatment.
The rest is what you would want anyway. The racks, the trays and the grill pan come out and are cleaned, the door comes apart where it splits so the faces between the panes are done, and the fan cover comes off so the carbon behind it goes with it. A single oven is £75, a double is £90, and there is no VAT to add.
Before you spray anything, what the supermarket tubs reach and what they do not is worth two minutes. If the words self cleaning are on the front of your cooker, three different systems are sold under that name. And what happens on the day is on the oven cleaning page.
Questions about catalytic liners
Is every rough panel in an oven a catalytic liner?
Not quite. Some ovens have a speckled easy clean enamel that looks matte but still feels smooth, and the fan cover at the back is a pressed plate rather than a liner. A liner drags on your palm. If yours is borderline, the model number on the plate inside the door frame settles it, and until it does, treat the walls as liners.
Do the liners come off to be cleaned?
How they are fixed differs by make, so the manual for your model says whether yours lift out. There is little to gain by it either way. In the oven or out of it they want hot water and a cloth, and taking a panel to the sink mostly tempts people into scrubbing it, which is the one thing that ruins them.
Caustic cleaner has already gone on mine. What now?
Rinse it off with hot water and a clean cloth, several times, so nothing is left sitting on the panels. The oven is safe to use and it will cook exactly as it did. What has gone is the panels' own ability to deal with grease, and that does not come back. New panels are the only way to get it back, so most people carry on and have the oven cleaned properly by hand instead.
Is the floor of the oven a liner as well?
Usually not. The base is normally plain enamel, which is lucky, because the floor is where spills land and enamel takes a soak and a blade held flat. So one cavity can need two treatments at once, a gentle hand on the side walls and proper work on the floor. Feel the base the way you felt the walls.
Should catalytic liners look patchy and stained?
Yes. A liner is not meant to look like enamel. Darkening and uneven patches are absorbed grease on its way out, and that is the panel doing what it is there for. What is not normal is a pale, stripped patch that appeared after a spray or a scouring pad, because that is the surface gone rather than dirt on it.
About East Cambs Oven Cleaning
Who we are and how we set our prices
We clean ovens, hobs, extractor hoods, range cookers, AGAs, microwaves and barbecues by hand, in the customer’s kitchen, across 31 towns and villages in East Cambridgeshire, Newmarket and west Suffolk from a base in Burwell, Cambridgeshire. A single oven is £75, the whole price list is published, and the price is fixed in writing before we set off.
Before setting those prices we read the published price lists of 11 oven cleaning businesses covering this patch, on 12 September 2026. 3 of them publish no price at all, and of the 25 pages ranking for oven cleaning across the county, 7 put a number on the page. How those figures were gathered, and when they were last checked.
Sources
Every outside claim on this page, with where it came from and the date it was read. Our own prices and the local price survey are published in full on the price list, with the log of when they were last checked.
See the sources
- How to use Catalytic Cleaning on your AEG ovenAEG (UK support) · read 23 September 2026That oven sprays and other cleaning agents damage a catalytic surface. The page says: "Do not clean the catalytic surface with oven sprays, abrasive cleaning agents, soap or other cleaning agents. This will damage the catalytic surface", and separately "Never put cleaning detergent on the catalytic liners." It also gives the mechanism: the liners absorb grease, which AEG says "becomes loosened when the oven reaches 250°C". Note the word: LOOSENED, not burnt off. AEG's own routine is to run the empty oven on a catalytic cleaning cycle and "leave it to self-clean for an hour", then wipe the bottom of the cavity with a soft cloth once it is cool, having first removed all accessories and removable shelf supports.
- Oven Pride, the manufacturer's own warnings and ingredientsOven Pride · read 23 September 2026What a caustic oven cleaner may and may not touch, from the label of the product this article names. It gives the contents as "5 - <12% Sodium Hydroxide" and the hazard as "May be corrosive to metals & Causes severe skin burns and eye damage". Its DO NOT list is the striking part: do not "use on aluminium, zinc, copper, tin, painted, damaged, self-cleaning or non-stick surfaces", and do not let it "come into contact with oven trim, hinges, glass oven door, door seals, pilot light or heating and fan elements". So the maker itself rules out most of the oven, including self-cleaning surfaces, which is what a catalytic liner is.
Ten seconds of checking saves a set of panels
Liners or plain enamel, the price is the same and the walls are felt before anything touches them. East Cambridgeshire and west Suffolk, from Burwell, Cambridgeshire, with the number fixed in writing first.
Get a price